LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 120 (Engine Mechanical - 4.6L - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Engine Flywheel Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying 8 Engine Flywheel Mounting Bolts
    GM1480384Courtesy of GENERAL MOTORS COMPANY
  1. Apply sealant to the flywheel bolts. Refer to Adhesives, Fluids, Lubricants, and Sealers .
  2. Place the engine flywheel in position against the crankshaft.
    3. CAUTION:

    Refer to Fastener Caution .

  3. Install the flywheel bolts.

    Tighten 

    • Tighten the bolts a first pass to 30 N.m (22 lb ft).
    • Tighten the bolts a final pass an additional 50 degrees using the J 45059 .
    4. Fig 2: Flywheel Holder
    GM651420Courtesy of GENERAL MOTORS COMPANY
  4. Remove the J 44214 from the engine block.
  5. Install the transaxle. Refer to Transmission Replacement .
scientia non olet · About LEMON Manuals