LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 120 (Engine Mechanical - 4.6L - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Drive Belt Tensioner Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Drive Belt Tensioner
    GM1660276Courtesy of GENERAL MOTORS COMPANY
  1. Position the drive belt tensioner to the left cylinder head. Ensure the anti-rotation pin is in the hole.
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the drive belt tensioner bolt.

    Tighten 

    Tighten the bolt to 50 N.m (37 lb ft).

  3. Install the drive belt. Refer to Drive Belt Replacement .
  4. Install new seal. Connect the A/C compressor suction hose to the A/C evaporator hose.
  5. Recharge the A/C system. Refer to Refrigerant Recovery and Recharging .
  6. Install the right engine mount strut. Refer to Engine Mount Strut Replacement - Right Side .
  7. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
scientia non olet · About LEMON Manuals