LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 120 (Engine Mechanical - 4.6L - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Drive Belt Idler Pulley Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Drive Belt Idler Pulley
    GM1660277Courtesy of GENERAL MOTORS COMPANY
  1. Position the drive belt idler pulley to the engine and finger starter the pulley bolt.
    2. CAUTION:

    Refer to Fastener Caution .

  2. Tighten the drive belt idler pulley bolt.

    Tighten 

    Tighten the bolt to 50 N.m (37 lb ft).

  3. Install the drive belt tensioner. Refer to Drive Belt Tensioner Replacement .
scientia non olet · About LEMON Manuals