Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring Replacement

WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Remove the inflatable restraint steering wheel module coil. Refer to Steering Wheel Inflatable Restraint Module Coil Replacement .
1	Steering Shaft Lock Plate Retaining Ring Procedure: Use the J 23653-SIR: compressor and the J 42137: adapter to remove the steering shaft lock plate retaining ring. Tip: Do not reuse the steering shaft lock plate retaining ring. Replace it. Special Tools J 23653-SIR: Steering Column Lock Plate Compressor J 42137: Cam Orientation Plate Adapter For equivalent regional tools, refer to Special Tools .
2	Steering Shaft Lock Plate Tip: The steering shaft lock plate can only be installed one way, align it to the solitary larger spline on the steering shaft.
3	Turn Signal Cancel Cam Tip: Ensure the turn signal cancel cam is aligned to the turn signal multifunction switch when reinstalling.
4	Steering Shaft Upper Bearing Spring