Component Testing
WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
Tilt/Telescope Switch
- Ignition OFF, disconnect the harness connector at the tilt/telescope switch.
- Test for infinite resistance between terminals 1, 2, 3, and 5 with the switch in the neutral position:
- If less than the specified range, replace the tilt/telescope switch.
- Test for less than 1 ohm between terminal 4 and terminals 1, 2, 3, and 5 with the switch in each appropriate position.
- If greater than the specified value, replace the tilt/telescope switch.