Front Bumper Fascia Molding Replacement

WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Front Bumper Fascia Molding

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Remove front fascia. Refer to Front Bumper Fascia Replacement .
1	Remove Push-pin WARNING: Eye protection must be worn when drilling rivets to reduce the chance of personal injury.
2	Front Fascia Molding TIP: Disengage integral retainers.