Installation Procedure
WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
- Raise the support assembly with the transmission jack in position.
- Using dowel pins in the alignment holes (1), align the frame (2) with the vehicle.
- Install the 2 rear bolts and the 2 front bolts at the mounts.
Tighten
Tighten the bolts to 191 N.m (141 lb ft).
- Install the brackets at the forward support assembly mounts.
Tighten
Tighten the bolts to 86 N.m (63 lb ft).
- Install the air tube to the electronic level control compressor.
- Connect the electronic level control electrical connector and install the vent tube.
- Connect the electrical connectors to the support assembly (FE3).
- Install the electronic level control link (FE1) or links (FE3) to the control arms.
- Install the brake calipers. Refer to Rear Brake Caliper Replacement (J55) , Rear Brake Caliper Replacement (JL9) .
- Install the springs. Refer to Coil Spring Replacement (FE7) , Coil Spring Replacement (FE1 and FE3) .
- Install the exhaust system. Refer to Exhaust System Replacement .
- Install the tires and the wheels. Refer to Tire and Wheel Removal and Installation .
CAUTION:
Refer to Fastener Caution .
NOTE:
Loosen the assemble brackets to prevent spinning when securing the front support assembly bolts.
Fig 3: Identifying Road Sensing Suspension or Automatic Level Control Electrical Connectors & Vent Hose