Installation Procedure

WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Frame Bushing Installer On Bushing

Courtesy of GENERAL MOTORS COMPANY

Install clamp J-45725 onto the bushing leaving about an 1/8 inch from the bottom of the bushing.

Fig 2: Aligning Split Of Bushing

Courtesy of GENERAL MOTORS COMPANY

Align the split of the bushing to the front of the frame.

Fig 3: Frame Bushing Installer

Courtesy of GENERAL MOTORS COMPANY

Using J-45725 install the bushing until the entire radius of the bushing is halfway recessed in the cradle.

Fig 4: Removing Clamp

Courtesy of GENERAL MOTORS COMPANY

Remove the J-45725 clamp.

Fig 5: Seating Lip Of The Bushing To The Bottom Of The Cradle Assembly

Courtesy of GENERAL MOTORS COMPANY

Using J-45725 install the bushing until the lip of the bushing is fully seated to the bottom of the cradle assembly.
Install the frame. Refer to Drivetrain and Front Suspension Frame Replacement (4.6L) .