Installation Procedure

WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View of Water Pump Drive Pulley

Courtesy of GENERAL MOTORS COMPANY

Place the water pump drive pulley in position on the intake camshaft.

Fig 2: Power Steering & Water Pump Pulley Remover

Courtesy of GENERAL MOTORS COMPANY

Install the water pump pulley onto the intake camshaft using the J 38823 . During installation, the tool will bottom out on the camshaft at the proper depth.

Fig 3: Identifying Intake Camshaft End Cap

Courtesy of GENERAL MOTORS COMPANY

CAUTION:

Refer to Fastener Caution .

Install the camshaft end cap.
Tighten

Tighten the cap to 2 N.m (18 lb in).
Install the water pump drive belt. Refer to Water Pump Belt Replacement .