LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 113 (Engine Cooling System) >> Repair Instructions >> Engine Coolant Thermostat Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View of Thermostat & Gasket
    GM611035Courtesy of GENERAL MOTORS COMPANY
  1. Install a NEW thermostat housing gasket into the water pump housing.
  2. Install the thermostat into the water pump housing.
  3. Install the thermostat housing.
    4. Fig 2: Identifying Thermostat Housing to Water Pump Inlet Bolts
    GM611039Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  4. Install the thermostat housing bolts.

    Tighten 

    Tighten the bolts to 10 N.m (89 lb in).

    5. Fig 3: View Of Radiator Outlet Hose At Thermostat Housing
    GM1664571Courtesy of GENERAL MOTORS COMPANY
  5. Install the radiator outlet hose (2) to the thermostat housing.
  6. Using the J 38185 , position the radiator outlet hose clamp (1) at the thermostat housing.
  7. Fill the cooling system. Refer to Cooling System Draining and Filling (Static Fill) , Cooling System Draining and Filling (Vac-N-Fill) .
  8. Install the air cleaner. Refer to Air Cleaner Assembly Replacement .
scientia non olet · About LEMON Manuals