LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 113 (Engine Cooling System) >> Repair Instructions >> Engine Coolant Heater Replacement - Right Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Coolant Heater & Bolt
    GM1667234Courtesy of GENERAL MOTORS COMPANY
  1. Position the coolant heater to the engine block.
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the coolant heater bolt.

    Tighten 

    Tighten the bolt to 10 N.m (89 lb in).

    3. Fig 2: Identifying Right Coolant Heater Electrical Connector
    GM1667236Courtesy of GENERAL MOTORS COMPANY
  3. Connect the coolant heater cord electrical connector (2) to the coolant heater electrical connector (1).
  4. Lower the vehicle.
scientia non olet · About LEMON Manuals