Installation Procedure
WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
- Position the coolant heater to the engine block.
- Install the coolant heater bolt.
Tighten
Tighten the bolt to 10 N.m (89 lb in).
- Connect the coolant heater cord electrical connector (3) to the coolant heater electrical connector (2).
- Remove the front air deflector. Refer to Front Air Deflector Replacement .
CAUTION:
Refer to Fastener Caution .