LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 113 (Engine Cooling System) >> Repair Instructions >> Drive Belt Tensioner Replacement - Water Pump >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Water Pump Drive Belt Tensioner
    GM1662860Courtesy of GENERAL MOTORS COMPANY
  1. Position the water pump drive belt tensioner to the water pump housing.
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the water pump drive belt tensioner studs.

    Tighten 

    Tighten the studs to 10 N.m (89 lb in).

  3. Install the water pump drive belt. Refer to Water Pump Belt Replacement .
scientia non olet · About LEMON Manuals