LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 113 (Engine Cooling System) >> Diagnostic Information and Procedures >> Cooling Fan Always On (Dual Fan) >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the KR20 cooling fan relay.
  2. Test for 70-110 Ω between terminals 85 and 86.
    • If not within the specified range, replace the KR20 cooling fan relay.
  3. Measure the resistance between the terminals listed below. The DMM should display OL.
    • 30 and 86
    • 30 and 87
    • 30 and 85
    • 85 and 87
      • If not the specified range, replace the KR20 cooling fan relay.
  4. Test for less than 2 Ω between terminals 30 and 87A.
    • If greater than the specified range, replace the KR20E cooling fan relay.
  5. Install a 20 A fused jumper wire between relay terminal 85 and 12 volts. Install a jumper wire between relay terminal 86 and ground. Test for less than 2 Ω between terminals 30 and 87.
    • If greater than the specified range, replace the KR20 cooling fan relay.
scientia non olet · About LEMON Manuals