LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 108 (Wiring Systems And Power Management - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> FCI Connectors (SIR) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

The orange connector position assurance (CPA) must be released first to disconnect or to connect the connector.

    Fig 1: View Of Lifting Orange CPA
    GM2374625Courtesy of GENERAL MOTORS COMPANY
  1. Lift the orange CPA vertically (avoid lifting on an angle to the connector) approximately 4 mm to release the connector. Use a small flat-bladed tool to help release the orange CPA. The orange CPA can also be released manually without any tools.
    2. Fig 2: Orange CPA
    GM2374627Courtesy of GENERAL MOTORS COMPANY
  2. Grab the connector on both sides and lift the connector vertically to disconnect the connector.
scientia non olet · About LEMON Manuals