LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 105 (Cellular System, Entertainment System, And Navigation System) >> Repair Instructions >> Cellular Communications/Digital Radio Antenna Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View of Digital Radio Antenna Connectors, Bolt, Expansion Sleeve, and Retainer
    GM863301Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    DO NOT apply paint or clear coat to the antenna. This will damage the function of the antenna, causing poor reception or loss of signal reception.

    CAUTION:

    Use care when removing or installing the headliner. Excessive bending will damage the headliner.

  1. Lower the headliner assembly. Do not remove from vehicle. Refer to Headlining Trim Panel Replacement (With PLA) , Headlining Trim Panel Replacement (Without PLA) .
  2. Remove the antenna cable connection from above the AM/FM antenna module.
  3. Remove the foam tape from the antenna cable connection.
  4. Disconnect the digital radio antenna connectors (1).
  5. Remove the antenna bolt (2) and expansion sleeve (3).
    6. Fig 2: View Of Antenna Assembly
    GM1491976Courtesy of GENERAL MOTORS COMPANY
  6. Remove the digital radio antenna.
scientia non olet · About LEMON Manuals