Steering Wheel Position Sensor Replacement (Power Steering Column with JL4)

WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View of Steering Wheel Position Sensor, Steering Shaft Seal & Retainer

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Remove the intermediate steering shaft. Refer to Intermediate Steering Shaft Replacement .
1	Steering Shaft Seal
2	Steering Shaft Lower Bearing Seal Retainer
3	Steering Wheel Position Sensor Procedure Disconnect any electrical connectors as needed. TIP: If reusing, secure the old steering wheel position sensor before removing it for proper alignment upon reinstallation. Refer to Steering Wheel Position Sensor Centering .