LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Instrument Panel System Displays & Gauges) >> Diagnostic Information and Procedures >> DTC P0520 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the engine oil pressure (EOP) switch.
  2. Ignition OFF, test for less than 1 ohm between the ground circuit terminal B and ground.
    • If greater than the specified range, test the ground circuit for an open/high resistance.
  3. Ignition ON, verify the scan tool Engine Oil Pressure Switch parameter is OK.
    • If not the specified value, test the signal circuit for a short to ground. If the circuit tests normal, replace the ECM.
  4. Ignition ON, install a 3A fused jumper wire between the signal circuit terminal A and the ground circuit terminal B. Verify the scan tool Engine Oil Pressure Switch parameter is Low.
    • If not the specified value, test the signal circuit for an open/high resistance. If circuit test normal, replace the ECM.
  5. If all circuits test normal, test or replace the engine oil pressure switch.
scientia non olet · About LEMON Manuals