Rocker Panel Molding Replacement

WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Molding Replacement - Rocker Panel

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Open both doors on the side that the lower rocker panel molding is being removed.
1	Rocker Panel Molding Clips (Qty: 6)
2	Rocker Panel Molding Retainers (Qty: 8) Tip: Using a trim retainer type release tool, disengage the lower retainers by gently prying downward at each retainer location prior to releasing the upper retainers from the lower rocker panel. Use the front fender clip to locate the rocker molding upon installation.
3	Rocker Panel Tip: Upon installation, ensure both doors are in the open position.