Installation Procedure

Fig 1: Loosen/Tighten Mounting Bolts

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: Before installing the hood, be sure to apply anti-corrosion treatment to the hood and hood hinge mating surfaces. Refer to Anti-Corrosion Treatment and Repair .

Install the hood (1) with the aid of a helper to the hood hinges (3), aligning the mating marks. Secure the hood with 2 mounting bolts at each hinge. Do not tighten fully.

Fig 2: View Of Retainers & Radiator Support Seal

Courtesy of GENERAL MOTORS CORP.

Install the washer hose assembly. Refer to Hose Replacement (Hose Connector to Washer Nozzle) .
Install the washer nozzles. Refer to Washer Nozzle Replacement .
Install the hood insulator. Refer to Hood Insulator Replacement .
Install the seven retainers and the radiator support seal.

Fig 3: Exploded View Of Hood Protector Clip

Courtesy of GENERAL MOTORS CORP.

Engage the two clips (2), and install the hood protector clip (1).

Fig 4: Loosen/Tighten Mounting Bolts

Courtesy of GENERAL MOTORS CORP.

Remove the protective covers from the front fenders (2).
Adjust the hood, if necessary. Refer to Hood Adjustment .