LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> G5 Base, Automatic >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 4T45-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions - On Vehicle >> Park/Neutral Position Switch Adjustment >> Adjustment

Park/Neutral Position Switch Adjustment: Adjustment

    Fig 1: Identifying Shift Control Cable, Lever & Electrical Connector At Transaxle Range (TR) Switch
    GM1233683Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the transaxle range switch electrical connectors from the switch.
  2. Remove the shift control cable from the transaxle range switch lever.
    3. Fig 2: Identifying Transaxle Range (PNP) Switch Lever
    GM1233687Courtesy of GENERAL MOTORS CORP.
  3. Remove the transaxle range switch lever and nut
    4. Fig 3: Identifying Transaxle Range Switch And Mounting Bolts
    GM1233691Courtesy of GENERAL MOTORS CORP.
  4. Make sure the transaxle manual shaft is in the Neutral position.
  5. Loosen, DO NOT REMOVE the transaxle range switch bolts.
    6. Fig 4: Identifying J 41545
    GM893833Courtesy of GENERAL MOTORS CORP.
  6. Insert the J 41545  as shown and rotate the switch until the tool drops onto position. See Special Tools .
    7. CAUTION: Refer to Fastener Caution .
  7. Tighten the transaxle range switch bolts to 20 N.m (15 lb ft).
  8. Remove the alignment tool.
    9. Fig 5: Identifying Transaxle Range (PNP) Switch Lever
    GM1233687Courtesy of GENERAL MOTORS CORP.
  9. Install the transaxle range switch lever and nut and tighten to 35 N.m (26 lb ft)
    10. NOTE: After adjusting the switch, verify the engine only starts in Park or Neutral. If the engine starts in any other position, adjust the switch.
    Fig 6: Identifying Shift Control Cable, Lever & Electrical Connector At Transaxle Range (TR) Switch
    GM1233683Courtesy of GENERAL MOTORS CORP.
  10. Connect the transaxle range switch electrical connectors to the switch.
  11. Install the shift control cable to transaxle range switch lever and verify proper operation.
scientia non olet · About LEMON Manuals