LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> G3 Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 67 (Engine Mechanical - 1.6L (LDE, LLU, And LXV) Or 1.8L (2H0) - Repair Instructions - On Vehicle) >> Oil Pump Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Crankshaft Sprocket & Engine Front Cover Assembly
    GM2049582Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
    NOTE: Do not reuse the engine front cover gasket.
  1. Install the engine front cover assembly (3) with the new gasket.

    Tighten:  Tighten the engine front cover assembly bolts to 20 N.m (14.7 lb ft).

  2. Install the crankshaft sprocket (2).
    3. Fig 2: Engine Coolant Pipe & Bracket Bolts
    GM2049581Courtesy of GENERAL MOTORS CORP.
  3. Install the engine coolant pipe (1) bolts.
  4. Install the engine coolant pipe (2) bracket bolt and then push the pipe into the oil cooler housing.
  5. Install the A/C compressor. Refer to Air Conditioning Compressor Replacement .
  6. Install the alternator. Refer to Generator Replacement (1.4L LDT, 1.6L LXV) .
  7. Install the power steering pump and bracket. Refer to Power Steering Pump Replacement (1.4L LDT and 1.6L LXV Engines) .
  8. Install the oil pan. Refer to Oil Pan Replacement .
  9. Install the timing belt. Refer to Timing Belt Replacement .
scientia non olet · About LEMON Manuals