LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> G3 Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 67 (Engine Mechanical - 1.6L (LDE, LLU, And LXV) Or 1.8L (2H0) - Repair Instructions - On Vehicle) >> Crankshaft Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Crankshaft, Seal, Caps & Bolts
    GM2049770Courtesy of GENERAL MOTORS CORP.
    NOTE: Check and confirm the sequence of the crankshaft caps and bearings.
  1. Remove the pistons and connecting rods. Refer to Piston, Connecting Rod, and Bearing Replacement .
  2. Remove the crankshaft cap bolts.
  3. Remove the crankshaft caps with journal bearings (1).
  4. Remove the crankshaft (2).
  5. Remove the crankshaft rear oil seal (3) with housing (4).
  6. Detach the crankshaft rear oil seal from the housing.
scientia non olet · About LEMON Manuals