LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> G3 Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 67 (Engine Mechanical - 1.6L (LDE, LLU, And LXV) Or 1.8L (2H0) - Repair Instructions - On Vehicle) >> Camshaft Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Take extreme care to prevent any scratches, nicks or damage to the camshafts and caps bearing surfaces.
  1. Remove the camshaft intake and exhaust sprockets. Refer to Camshaft Intake Sprocket with Actuator Replacement  and Camshaft Exhaust Sprocket with Actuator Replacement .
  2. Remove the timing belt tensioner. Refer to Timing Belt Replacement .
    3. Fig 1: Timing Belt Rear Cover & Bolts
    GM2049388Courtesy of GENERAL MOTORS CORP.
  3. Remove the timing belt rear cover (1).
    4. Fig 2: Camshaft Position Solenoid Valve Housing, Camshaft Caps & Bolts
    GM2049389Courtesy of GENERAL MOTORS CORP.
  4. Remove the camshaft position solenoid valve housing.
  5. Remove the camshaft cap bolts in sequence (1, 4, 2, 3).
  6. Remove the camshaft caps.
    7. Fig 3: Intake/Exhaust Camshafts With Seal Rings
    GM2049390Courtesy of GENERAL MOTORS CORP.
  7. Remove the intake (2)/exhaust (1)camshafts with the seal rings (3).
scientia non olet · About LEMON Manuals