LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> G3 Standard >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bolted Exterior Body Panels And Closures >> Repair Instructions >> Hood Primary Latch Release Cable Replacement >> Removal Procedure

Removal Procedure

    Fig 1: View of Screws and Hood Release Handle From Instrument Panel
    GM1252065Courtesy of GENERAL MOTORS CORP.
  1. Pull out the hood release handle in order to access the screws.
  2. Remove the screws and the hood release handle from the instrument panel.
    3. Fig 2: View of Screws and Splash Shield
    GM1252066Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Vehicle Lifting and Jacking Caution .
  3. Raise and suitably support the vehicle.
  4. Remove the front wheel. Refer to Tire and Wheel Removal and Installation .
  5. Remove the screws and the splash shield.
    6. Fig 3: Hood Secondary Latch
    GM1719808Courtesy of GENERAL MOTORS CORP.
  6. Open the hood.
  7. Remove the screws and the hood secondary latch.
    8. Fig 4: Hood Release Cable
    GM1719812Courtesy of GENERAL MOTORS CORP.
  8. Remove the cable from the hood release handle.
  9. Remove the cable from inside the vehicle.
scientia non olet · About LEMON Manuals