LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> G3 Standard >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bolted Exterior Body Panels And Closures >> Repair Instructions >> Front Fender Replacement (Notchback) >> Removal Procedure

Removal Procedure

    Fig 1: Front Wheel Well Splash Shield
    GM1719817Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Vehicle Lifting and Jacking Caution .
  1. Raise and suitably support the vehicle.
  2. Remove the necessary bolts from the splash shield.
  3. Remove the headlamp assembly. Refer to Headlamp Replacement (Notchback) or Headlamp Replacement (Hatchback) .
  4. Remove the two screws attaching the front fascia to the fender.
    5. Fig 2: Screws Underneath Front Bumper Fascia
    GM1719818Courtesy of GENERAL MOTORS CORP.
  5. Remove the screws underneath the front bumper fascia.
    6. Fig 3: Screw Securing Front Bumper Fascia To Fender
    GM1719820Courtesy of GENERAL MOTORS CORP.
  6. Remove the bolt at the base of the fender.
  7. Remove the air inlet panel. Refer to Air Inlet Grille Panel Replacement .
    8. Fig 4: Bolt At Base Of Windshield Pillar
    GM1719822Courtesy of GENERAL MOTORS CORP.
  8. Open the front door. Remove the bolt at the base of the windshield pillar.
    9. Fig 5: Bolts Along The Top Of Fender
    GM1719824Courtesy of GENERAL MOTORS CORP.
  9. Remove the bolts along the top of the fender.
  10. Remove the repeater lamp. Refer to Repeater Lamp Replacement .
  11. Remove the fender.
scientia non olet · About LEMON Manuals