Catalytic Converter Guard Replacement
WARNING: This page is about a different car, the 2008 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| Preliminary Procedure: Remove the engine protection shield. Refer to Engine Protection Shield Replacement . |
|
| 1 | Catalytic Converter Guard Bolt (Qty: 4)
NOTE:
Refer to Fastener Notice
.
Tighten: 30 N.m (22 lb ft) |
| 2 | Catalytic Converter Guard |