Inflatable Restraint Vehicle Rollover Sensor Replacement

WARNING: This page is about a different car, the 2008 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Inflatable Restraint Vehicle Rollover Sensor

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
CAUTION: Refer to SIR Caution . Preliminary Procedure Disable the SIR. Refer to SIR Disabling and Enabling . Remove the Transmission Control Bracket. Refer to Transmission Control Bracket Replacement .
1	Inflatable Restraint Roll Over Sensor Nuts (Qty: 3) NOTE: Refer to Fastener Notice . Tighten: 10 N.m (88 lb in)
2	Inflatable Restraint Roll Over Sensor Procedure Disconnect electrical connectors. Enable the SIR. Refer to SIR Disabling and Enabling .

Callout

Component Name

CAUTION: Refer to SIR Caution .

Preliminary Procedure

Disable the SIR. Refer to SIR Disabling and Enabling .
Remove the Transmission Control Bracket. Refer to Transmission Control Bracket Replacement .

Inflatable Restraint Roll Over Sensor Nuts (Qty: 3)

NOTE: Refer to Fastener Notice .

Tighten: 10 N.m (88 lb in)

Inflatable Restraint Roll Over Sensor

Procedure

Disconnect electrical connectors.
Enable the SIR. Refer to SIR Disabling and Enabling .