Transmission Mount Replacement

WARNING: This page is about a different car, the 2008 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Transmission Mount, Crossmember Nut & Bolts

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle . Support the transmission with a transmission jack.
1	Transmission Mount to Crossmember Nut (Qty: 2) NOTE: Refer to Fastener Notice . Tighten: 40 N.m (30 lb ft)
2	Transmission Mount Bolt (Qty: 2) Tighten: 50 N.m (30 lb ft)
3	Transmission Mount Tip: Raise the transmission with the transmission jack just enough to remove the transmission mount.