LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Vibe Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 88 (Automatic Transmission - 6L50/6L80/6L90 - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> On-Vehicle Repair Instructions >> Range Selector Lever Cable Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the transmission shift control lever to the park position.
  2. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  3. Ensure the transmission range selector lever is positioned to mechanical park.
    4. Fig 1: Range Selector Cable Retaining Clip
    GM1971076Courtesy of GENERAL MOTORS CORP.
  4. Remove the range selector cable retaining clip (2).
  5. Remove the range selector cable (3) from the range selector cable bracket (1) at the transmission.
  6. Remove the range selector cable (3) from the transmission range selector lever ball stud (4).
  7. Lower the vehicle and ensure that the shift lever is still in the park position.
    8. Fig 2: View Of Range Selector Cable End And Transmission Shift Control Lever Ball Stud
    GM1967928Courtesy of GENERAL MOTORS CORP.
  8. Remove the console. Refer to Front Floor Console Replacement .
  9. Remove the range selector cable end (2) from the transmission shift control lever ball stud.
  10. Remove the range selector cable (1) from the transmission shift control lever housing.
    11. Fig 3: Range Selector Cable Grommet
    GM1971151Courtesy of GENERAL MOTORS CORP.
  11. Remove the range selector cable grommet (1) from the floor panel.
  12. Remove the range selector cable from the vehicle.
scientia non olet · About LEMON Manuals