LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Vibe Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 88 (Automatic Transmission - 6L50/6L80/6L90 - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> On-Vehicle Repair Instructions >> Range Selector Lever Cable Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Route the range selector cable through the hole in the floor panel.
  2. Ensure that the transmission shift control lever is in the park position.
    3. Fig 1: Range Selector Cable Grommet
    GM1971151Courtesy of GENERAL MOTORS CORP.
  3. Install the range selector cable grommet (1) to the floor panel.
    4. Fig 2: Range Selector Cable
    GM1967928Courtesy of GENERAL MOTORS CORP.
  4. Install the range selector cable (1) to the transmission shift control lever housing.
  5. Install the range selector cable end (2) to the transmission shift control lever ball stud.
  6. Install the console. Refer to Front Floor Console Replacement .
  7. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  8. Ensure that the transmission range selector lever is in the mechanical park position.
    9. Fig 3: Range Selector Cable
    GM1971076Courtesy of GENERAL MOTORS CORP.
  9. Install the range selector cable (3) into the range selector cable bracket (1) at the transmission.
  10. Install the range selector cable retaining clip (2).
  11. Install the range selector cable (3) to the transmission range selector lever ball stud (4).
  12. Lower the vehicle.
scientia non olet · About LEMON Manuals