Input and Output Speed Sensor Assembly Installation
WARNING: This page is about a different car, the 2008 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| 1 | A/Trans Input and Output Speed Sensor Wiring Harness Clip (Qty: 2) Tip: Inspect the 2 wiring harness clips for damage. Replace if damaged. |
| 2 | A/Trans Input and Output Speed Sensor Assembly |
| 3 | Bolt M6 x 20 (Qty: 2)
NOTE:
Refer to Fastener Notice
.
Tighten: 12 N.m (106 lb in) |