Installation Procedure
WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
- Connect the upper switch (1) electrical connector.
- Install the upper switch (1) into the upper retainer.
- Twist the switch clockwise until fully seated.
- Adjust the switch. Refer to Torque Converter Clutch/Cruise Control Release Switch Replacement .
- Install the left closeout/insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side .
IMPORTANT:
When installing the brake pedal switches, ensure that the brake pedal remains in the full up or at rest position.
IMPORTANT:
The release switch assembly and the stoplamp switch assembly cannot be adjusted until after the brake booster pushrod is assembled to brake pedal assembly. Incorrect adjustment may cause the cruise control system to not work properly.