LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Vibe Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 206 (Automatic Transmission - 4T80-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - On Vehicle >> Detent Lever and Roller Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the detent lever (17) and the actuator rod (21).
  2. You must hold the detent lever (17) in place when installing the manual shaft nut (18) in order to prevent damage to the actuator rod (21).
    3. CAUTION: Refer to Fastener Caution .
  3. Install the 15 mm manual shaft nut (18).

    Tighten:  Tighten the manual shaft to detent lever nut to 8-14 N.m (6-10 lb ft).

  4. Install the 13 mm detent roller bolt pivot arm, the sleeve, and the washer (26).

    Tighten:  Tighten the detent lever and roller assembly bolt to 8-14 N.m (6-10 lb ft).

    5. Fig 1: Identifying Detent Spring, Lever, Manual Shaft Nut, & Actuator Rod
    GM687598Courtesy of GENERAL MOTORS CORP.
  5. Using a pair of pliers, grasp the detent roller end of the detent spring (27). Install the detent spring (27).
  6. Install the lower controls and valve assembly. Refer to Lower Controls Assembly Installation .
  7. Install the scavenge screens. Refer to Transfer Oil Pump Inlet Screen and Pipe Seal Replacement .
scientia non olet · About LEMON Manuals