Replacement Procedure

WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Prying Out Right And Left Axle Seals

Courtesy of GENERAL MOTORS CORP.

Using a screw driver remove the right and left axle seals (37, 125) by prying them out.

Fig 2: Installing Axle Seals With J 39051-1 & J 39051-2

Courtesy of GENERAL MOTORS CORP.

Using the J 39051-1: right seal driver and the J 39051-2: left seal driver, install the new axle seals (37, 125). Use the output shaft (57) to pilot the seals and the tool into the case. Ensure that the snap rings are installed on the output shaft.