Steering Column Trim Cover Replacement
WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
Courtesy of GENERAL MOTORS CORP.
| Callout |
Component Name |
|
Preliminary Procedures
- Remove the steering wheel. Refer to Steering Wheel Replacement .
- If equipped with a manual steering column, remove the tilt lever. Refer to Tilt Lever Replacement .
- If equipped with a power steering column, remove the driver knee bolster. Refer to Driver Knee Bolster Replacement
.
|
| 1 |
Steering Column Lower Trim Cover Bolt (Qty: 2)
Tighten:
3 N.m (27 lb in)
|
| 2 |
Steering Column Lower Trim Cover Procedure
- If equipped with a power steering column, disconnect any electrical connectors as needed.
- The rear of the steering column lower trim cover is engaged in a rubber steering column shroud that it must be disconnected from before it can be removed.
- If equipped with AN3, disconnect the shift lever seal from the steering column lower trim cover.
- Transfer any parts as needed.
|
| 3 |
Steering Column Upper Trim Cover Bolt Tighten:
1.5 N.m (13 lb in)
|
| 4 |
Steering Column Upper Trim Cover Procedure
- If equipped with AN3, disconnect the shift lever seal from the steering column upper trim cover.
- The rear of the steering column upper trim cover is engaged in a rubber steering column shroud that it must be disconnected from before it can be removed.
|