LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Vibe L4-1.8L >> Repair and Diagnosis >> Transmission and Drivetrain >> Manual Transmission/Transaxle >> Sensors and Switches - M/T >> Clutch Pedal Position Sensor / Switch >> Service and Repair >> Clutch Pedal Engine Start Switch Replacement

Clutch Pedal Engine Start Switch Replacement



Clutch Pedal Engine Start Switch Replacement

Removal Procedure

1. Disconnect the clutch start switch electrical connector.




2. Remove the clutch start switch retaining nut, then the start switch.



Installation Procedure


Notice: Refer to Fastener Notice (Fastener Notice).

1. Install the clutch start switch and retaining nut.

Tighten the retaining nut to 16 N.m (12 lb ft).

2. Connect the clutch start switch electrical connector.
3. Check the clutch start switch for proper operation.


scientia non olet · About LEMON Manuals