Rear Suspension

Rear Wheel Bearing and Hub Replacement

Removal Procedure

1. Remove the brake drum. Refer to Brake Drum Replacement (Removal and Replacement).




2. If the vehicle has ABS, disconnect the rear wheel speed sensor connector (3). Position the connector to the side.
3. Remove the 4 bolts (1, 2, 4, 5).
4. Remove the wheel bearing and hub assembly.



Installation Procedure






Notice: Refer to Fastener Notice (Fastener Notice).

1. Install the wheel bearing and hub assembly and the 4 bolts (1, 2, 4, 5).

Tighten the bolts to 61 N.m (45.0 lb ft).

2. If the vehicle has ABS, connect the rear wheel speed sensor connector (3).
3. Install the brake drum. Refer to Brake Drum Replacement (Removal and Replacement).
4. If the vehicle has ABS, perform the vehicle system check. Refer to Diagnostic System Check - Vehicle (Initial Inspection and Diagnostic Overview).