LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Vibe Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Seats >> Seat Hardware, Seat Trim, And Upholstery >> Repair Instructions >> Rear Split Folding Seat Back Cushion Cover and Pad Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Rear Seat Back Release Latch Components
    GM849131Courtesy of GENERAL MOTORS CORP.
  1. Install the rear seat back cushion pad (5) to the frame (4), if removed.
  2. Install the rear seat back latch (8), if removed. Refer to Rear Seat Back Release Latch Replacement .
  3. Install the rear seat back cushion cover (6) to the seat back cushion (5).
  4. Install the seat latch retainer (10) and knob (11).
    5. Fig 2: Hog Ring Pliers And Rear Seat Cushion
    GM404793Courtesy of GENERAL MOTORS CORP.
  5. Use hog ring pliers (1) to install new hog rings. Ensure that the rear seat back cushion cover is secured to the cushion (2).
  6. Install the plastic retainers which secure the seat back cushion cover to the back of the seat.
    7. Fig 3: Rear Seat Back Release Latch Components
    GM849131Courtesy of GENERAL MOTORS CORP.
  7. Install the rear seat back cushion. Refer to Rear Split Folding Seat Back Replacement .
  8. Install the rear seat head restraint (1). Refer to Rear Seat Head Restraint Replacement .
scientia non olet · About LEMON Manuals