LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Vibe Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Seats >> Seat Hardware, Seat Trim, And Upholstery >> Repair Instructions >> Rear Seat Replacement >> Installation Procedure

Installation Procedure

  1. Place the rear seat to the anchors.
    2. NOTE: Refer to FASTENER NOTICE .
    Fig 1: Plastic Hinge Covers, Hinge Bolts, Lower Bolts And Rear Seat
    GM833610Courtesy of GENERAL MOTORS CORP.
  2. Install the lower seat bolts (3).

    Tighten:  Tighten the lower seat bolts (3) to 18 N.m (13 lb ft).

  3. Install center seat belt retractor, if removed. Refer to Seat Belt Retractor Replacement - Center Rear .
  4. Install the seat back hinge bolts (2).

    Tighten:  Tighten the seat back hinge bolts (2) to 18 N.m (13 lb ft).

  5. Install the plastic hinge covers (1).
  6. Install the rear seat to its original position.
scientia non olet · About LEMON Manuals