LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Vibe Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Seats >> Seat Hardware, Seat Trim, And Upholstery >> Repair Instructions >> Rear Seat Cushion Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Seat Cushion Components
    GM849882Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Slide the rear seat cushion into position. Ensure that the seat belt buckles are properly position through the cushion.
  2. Install the 2 lower mounting bolts (4)

    Tighten:  Tighten the lower mounting bolts (4) to 41 N.m (30 lb ft).

  3. Install the 2 pivot bolts (2).

    Tighten:  Tighten the pivot bolts (2) to 18 N.m (13 lb ft).

  4. Install the rear seat back trim panel. Refer to Rear Seat Back Cushion Trim Panel Replacement (Left)  or Rear Seat Back Cushion Trim Panel Replacement (Right) .
scientia non olet · About LEMON Manuals