LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Vibe Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Seats >> Seat Hardware, Seat Trim, And Upholstery >> Repair Instructions >> Rear Seat Back Cushion Outer Hinge Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Outer Hinge And Bolt
    GM833400Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE .
  1. Install the rear seat back cushion outer hinge (1) to the vehicle. Secure the support with the 1 bolt (2).

    Tighten:  Tighten the outer hinge bolt to 18 N.m (13 lb ft).

  2. Install the rear seat back cushion. Refer to Rear Split Folding Seat Back Replacement .
scientia non olet · About LEMON Manuals