LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Torrent GXP, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine Mechanical - 3.4L) >> Repair Instructions - On Vehicle >> Valve Rocker Arm and Push Rod Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Push Rods
    GM187046Courtesy of GENERAL MOTORS CORP.
  1. Coat the ends of the push rods using prelube GM P/N 1052367 (Canadian P/N 992869) or the equivalent.
    2. IMPORTANT: The intake valve push rods measure 146.0 mm (5.75 in) in length. The exhaust valve push rods measure 152.5 mm (6.0 in) in length.
  2. Install the push rods in their original location.
    3. Fig 2: View Of Valve Rocker Arm
    GM54392Courtesy of GENERAL MOTORS CORP.
  3. Coat the rocker arm friction surfaces using prelube GM P/N 1052367 (Canadian P/N 992869) or the equivalent.
    4. IMPORTANT: Shims may be required under the valve rocker arm pedestals if reconditioning has been performed on the cylinder head or its components.
  4. Install the valve rocker arms in their original positions.
    5. NOTE: Refer to Fastener Notice .
  5. Install the valve rocker arm bolts.

    Tighten:  Tighten the bolts to 32 N.m (24 lb ft).

  6. Install the valve rocker arm cover(s). Refer to Valve Rocker Arm Cover Replacement - Left Side  and/or Valve Rocker Arm Cover Replacement - Right Side .
scientia non olet · About LEMON Manuals