LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Torrent GXP, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine Mechanical - 3.4L) >> Repair Instructions - On Vehicle >> Valve Rocker Arm Cover Replacement - Right Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Cylinder Head To Lower Intake Manifold Joint
    GM190588Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: All gasket mating surfaces need to be free of oil and foreign material. Refer to Sealers, Adhesives, and Lubricants  for the correct part number to use to clean surfaces.
    IMPORTANT: Apply sealer at the cylinder head to lower intake manifold joint. Refer to Sealers, Adhesives, and Lubricants  for the correct part number.
  1. Apply sealant at the cylinder head to lower intake manifold joints (1).
    2. Fig 2: View Of Valve Rocker Arm Cover - Right
    GM60846Courtesy of GENERAL MOTORS CORP.
  2. Install a new gasket to the valve rocker arm cover. Ensure the gasket is properly seated in the groove of the valve rocker arm cover.
    3. NOTE: Refer to Fastener Notice .
  3. Install the valve rocker arm cover.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

    4. Fig 3: Identifying PCV Fresh Air Pipe At Valve Cover
    GM1087858Courtesy of GENERAL MOTORS CORP.
  4. Connect the PCV fresh air pipe (1) to the right valve rocker arm cover.
  5. Install the ignition control module bracket with the ignition control module and spark plug wired still attached. Refer to Ignition Control Module Bracket Replacement .
  6. Install the generator bracket. Refer to Generator Bracket and Engine Lift Bracket Replacement (LNJ) .
  7. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .
scientia non olet · About LEMON Manuals