LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Torrent GXP, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine Mechanical - 3.4L) >> Repair Instructions - On Vehicle >> Fuel Injector Sight Shield Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Intake Manifold Studs
    GM1870247Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. If the injector sight shield studs were removed, install the studs to the intake manifold.

    Tighten:  Tighten the studs to 10 N.m (89 lb in).

    2. Fig 2: Identifying Injector Sight Shield
    GM1870245Courtesy of GENERAL MOTORS CORP.
  2. Install the injector sight shield to the studs.
    3. Fig 3: Identifying Oil Filler Tube, Oil Cap & EGR Electrical Connector
    GM1870244Courtesy of GENERAL MOTORS CORP.
  3. Connect the EGR electrical connector (3).
  4. Install the oil filler tube (2) and the oil cap (1).
scientia non olet · About LEMON Manuals