LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Torrent GXP, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine Mechanical - 3.4L) >> Repair Instructions - On Vehicle >> Engine Mount Replacement - Right Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Right Engine Mount To Frame Rail Nuts
    GM1398175Courtesy of GENERAL MOTORS CORP.
  1. Position the engine mount onto the frame rail studs.
    2. NOTE: Refer to Fastener Notice .
  2. Install the engine mount to frame rail stud nuts.

    Tighten:  Tighten the nuts to 110 N.m (81 lb ft).

    3. Fig 2: View Of Right Engine Mount To Bracket Bolts
    GM1398174Courtesy of GENERAL MOTORS CORP.
  3. Install the engine mount to engine mount bracket bolts. Take care when aligning the engine mount to engine mount bracket bolt holes, while hand tightening all the bolts.
  4. Tighten the engine mount to engine mount bracket bolts.

    Tighten:  Tighten the bolts to 50 N.m (81 lb ft).

  5. Lower the vehicle.
  6. Remove the engine support. Refer to Engine Support Fixture .
  7. Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
scientia non olet · About LEMON Manuals