LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Torrent GXP, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine Mechanical - 3.4L) >> Repair Instructions - On Vehicle >> Drive Belt Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Drive Belt
    GM1370537Courtesy of GENERAL MOTORS CORP.
  1. Install the drive belt to all the pulleys except the right idler pulley.
  2. Install the right engine mount. Refer to Engine Mount Replacement - Right Side .
  3. Depending on which method was used to support the engine. Remove the floor jack from under the engine oil pan or remove the engine support fixture.
    4. Fig 2: Drive Belt Routing
    GM1309849Courtesy of GENERAL MOTORS CORP.
  4. Using J 39914  rotate the drive belt tensioner away from the drive belt.
  5. Install the drive belt to the right idler pulley (2).
  6. Carefully release J 39914  allowing the drive belt tensioner (8) to come in contact with the drive belt.
  7. Remove J 39914  from the drive belt tensioner (8).
  8. Inspect the drive belt to insure the belt is properly centered on all pulleys (1-8).
  9. Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
scientia non olet · About LEMON Manuals