LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Torrent GXP, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine Mechanical - 3.4L) >> Repair Instructions - On Vehicle >> Drive Belt Idler Pulley Replacement - Lower >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Lower Belt Idler Pulley
    GM1317163Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the lower belt idler pulley and bolt to the engine cover.

    Tighten:  Tighten the bolt to 50 N.m (37 lb ft).

  2. Install the engine splash shield. Refer to Engine Splash Shield Replacement .
  3. Install the right front wheel. Refer to Tire and Wheel Removal and Installation .
  4. Lower the vehicle.
    5. Fig 2: View Of Drive Belt
    GM1309849Courtesy of GENERAL MOTORS CORP.
  5. Insure the drive belt is properly centered on all the pulleys except the right idler pulley (3).
  6. Using J 39914  rotate the drive belt tensioner away from the drive belt.
  7. Install the drive belt to the right idler pulley (2).
  8. Carefully release J 39914  allowing the drive belt tensioner (8) to come in contact with the drive belt.
  9. Remove J 39914  from the drive belt tensioner (8).
  10. Inspect the drive belt to insure the belt is properly centered on all the pulleys (1-8).
scientia non olet · About LEMON Manuals