LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Torrent GXP, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine Mechanical - 3.4L) >> Repair Instructions - Off Vehicle >> Engine Front Cover Installation

Engine Front Cover Installation

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Applying Sealer To Lower Tabs Of Engine Front Cover Gasket
    GM61819Courtesy of GENERAL MOTORS CORP.
  1. Install the engine front cover gasket.
  2. Apply sealer GM P/N 12346004 (Canadian P/N 10953480) or equivalent to both sides of the lower tabs of the engine front cover gasket. Apply the sealer no less than 5.0 mm (0.20 in) wide.
    3. Fig 2: View Of Engine Front Cover & Bolts
    GM909617Courtesy of GENERAL MOTORS CORP.
  3. Install the engine front cover.
    4. NOTE: Refer to Fastener Notice .
  4. Install the engine front cover bolts (545).

    Tighten:  Tighten the engine front cover bolts to 27 N.m (20 lb ft).

  5. Install the engine front cover bolts (540, 541).

    Tighten:  Tighten the engine front cover bolts to 55 N.m (41 lb ft).

    6. Fig 3: View Of Heater Outlet Pipe Adapter
    GM1369269Courtesy of GENERAL MOTORS CORP.
  6. Install the heater outlet pipe adapter (319).
  7. Install the heater outlet pipe adapter bolt (308).

    Tighten:  Tighten the heater outlet pipe adapter bolt to 12 N.m (106 lb in).

scientia non olet · About LEMON Manuals