LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Torrent GXP, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine Mechanical - 3.4L) >> Repair Instructions - Off Vehicle >> Crankshaft Balancer Installation >> Tools Required

Tools Required

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Installing J 29113 Onto Crankshaft
    GM909647Courtesy of GENERAL MOTORS CORP.
  1. Apply sealer GM P/N 12378521 (Canadian P/N 88901148) or the equivalent to the keyway of the crankshaft balancer.
  2. Place the crankshaft balancer into position over the key in the crankshaft.
    3. NOTE: Do NOT use a power-assisted tool with the special tool in order to remove or install this component. You cannot properly control the alignment of this component using a power-assisted tool, and this can damage the component.
  3. Install the J 29113  onto the crankshaft. See Special Tools .
  4. Rotate the hex nut on the J 29113  to install the crankshaft balancer onto the crankshaft. See Special Tools .
  5. Remove the J 29113  from the crankshaft. See Special Tools .
    6. Fig 2: View Of Crankshaft Balancer Bolt & Washer
    GM909519Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  6. Install the used crankshaft balancer bolt.

    Tighten:  Tighten the used crankshaft balancer bolt to 125 N.m (92 lb ft).

  7. Remove the used crankshaft balancer bolt.
  8. Install the NEW crankshaft balancer bolt.

    Tighten: 

    1. Tighten the crankshaft balancer bolt a first pass to 125 N.m (92 lb ft).
    2. Tighten the crankshaft balancer bolt a final pass to 130 degrees using the J 45059  . See Special Tools .

scientia non olet · About LEMON Manuals